BA3258HFP Dual Output LDO Regulator

29 June 2020 - 0 Comments

BA3258HFP Dual Output LDO Regulator

BA3258HFP Pinout

The BA3258HFP is fixed 2-output low-saturation, low dropout voltage regulator with a voltage accuracy at both outputs of ±2%. This voltage regulator incorporates both over-current protection and thermal shutdown (TSD) circuits in order to prevent damage due to output short-circuiting and overloading, respectively.

BA3258HFP Pinout Configuration

Pin No.	Pin Name	Description
1	Vcc	Power Supply Pin
2	V_{02_}S	Output Voltage Monitor Pin
3	GND	Ground Pin
4	V₀₂	1.5V Output pin
5	V₀₁	3.3V Output Pin

Features

Input Supply Voltage: 4.75V to 14V
Output Voltage: 3.3V, 1.5V
Output Current: 1A
Output Type: Fixed
Dropout Voltage: 1.1 V
PSRR / Ripple Rejection - Typ: 52dB (120Hz)
High Ripple Rejection
Pd - Power Dissipation: 2.3 W
Protection Features: Over Current, Over Temperature
Available in TO-263-6, D²Pak (5 Leads + Tab), TO-263BA Packages

Note: The complete technical details can be found in the BA3258HFP datasheet given at the end of this page.

BA3258HFP Equivalents

BA33D15HFP, BA33D18HFP

Alternative LDO Regulators

LP2985, AMS1117, MIC5225

BA3258HFP Introduction

The BA3258HFP is an industry-grade, low cost, single-chip, high current LDO Regulator, which has an input voltage of 14V max, this IC features dual output stage. It can produce two regulated output voltages one 3.3V, and one 1.5V from a single input. This is a very space-efficient LDO that comes in an HRP5 package.

The BA3258HFP has a quiescent current of 10mA with an operating temperature range from -40°C to +125°C. BA3258HFP is generally used in include FPDs, TVs, DSPs, DVDs, and other battery-Powered Equipment’s.

How to use the BA3258HFP LDO Regulator

BA3258HFP low dropout regulator comes in 5 and package in 2 pins are output voltage pins. Supply the input voltage to the V-in pin and we get the regulated 3.3V 1.5V at the output pins. The input and output capacitors are used for ripple filtering. Connect a ceramic capacitor with a capacitance of approximately 3.3μF between VCC and GND close to the pins. Also, connect a 1µf capacitor between Vo and GND pins in order to prevent output oscillation.