BP3316D LED Driver IC
The BP3316D is a high precision primary-side LED Driver IC that is commonly used in powering the backlight of LCD/LED displays or to drive sensitive LEDs at constant current. This IC comes with single-stage Active PFC, specially designed for universal input offline flyback or buck-boost constant current LED lighting.
Pin Description of BP3316D
|
Pin Number |
Pin Name |
Description |
|
1 |
COMP |
Loop Compensation Node. This pin connects a capacitor to GND for Stabilization of the control loop and achieving accurate LED current. |
|
2 |
VCC |
Power Supply Pin |
|
3 |
FB |
Feedback Voltage Input Pin |
|
4 |
CS |
Current Sense Pin |
|
5, 6 |
DRAIN |
Internal HV Power MOSFET Drain |
|
7, 8 |
GND |
Ground Pin |
Specifications & Features of BP3316D
- Operating Voltage: 8.5V to 18
- Maximum sink current: 5mA
- Integrated 650V Power MOSFET
- ±3% LED Current Accuracy
- Ultra-Low (33uA) Startup Current
- Auto Fault Recovery
- Available in DIP-8 package
Note: Complete Technical Details can be found at the BP3316D datasheet given at the end of this page.
Alternative to BP3316D: OB3350, SSL5015
Other Display Driver IC: LM3914, LM3915, MAX7219
How to Use BP3316D
The BP3316D is specially designed for constant current LED lighting. Operating in critical conduction mode, the driver achieves high power factor, low THD, and high efficiency. This LED driver IC provides many protection features to improve the system reliability, including LED open circuit protection, LED short circuit protection, VCC over-voltage protection, VCC under-voltage protection, CS resistor open protection and cycle by cycle current limit.
So if you looking for an LED driver IC with above specifications then BP3316D might be a good choice for you.
How to use BP3316D
An application circuit from BP3316D IC datasheet is given below:
The VCC pin is powered using the AC power source. A bypass capacitor is connected from this pin to GND. When the VCC pin voltage reaches the turn-on threshold, the internal circuits start working, the COMP pin voltage is pulled up to 1.5V quickly. The FB pin is used to detect the transformer demagnetization signal and the output voltage. CS pin is connected to ground through a resistor. It is used to sense the power MOSFET current.
Applications of BP3316D
- LED Bulb, Spot Light
- PAR30, PAR38 LED Lamp
- T8/T10 LED String
- Other LED Lighting
2D-Model BP3316D
Dimensions for BP3316D IC given below. These dimensions are for the DIP-8 package. If you are using different package IC please refer to the BP3316D datasheet.
