LM393 Sound Detection Sensor Module

23 April 2020 - 0 Comments

Sound Detection Sensor Module

Sound Detection Sensor Module Pinout

Sound detection sensor module detects the intensity of sound where sound is detected via a microphone and fed into an LM393 op-amp. It comprises an onboard potentiometer to adjust the setpoint for sound level.

Sound Detection Sensor Module Pin Configuration

Pin Name	Description
VCC	The Vcc pin powers the module, typically with +5V
GND	Power Supply Ground
DO	Digital Output Pin. Directly connected to digital pin of Microcontroller
AO	Analog Output Pin. Directly connected to an analog pin of Microcontroller

Sound Detection Sensor Module Features & Specifications

Operating Voltage: 3.3V to 5V DC
LM393 comparator with threshold preset
PCB Size: 3.4cm * 1.6cm
Induction distance: 0.5 Meter
Operating current: 4~5 mA
Microphone Sensitivity (1kHz): 52 to 48 dB
Easy to use with Microcontrollers or even with normal Digital/Analog IC
Small, cheap and easily available

Alternate Sensor Modules: IR Sensor Module, ADXL335 Accelerometer Module, HMC5883L Magnetometer Module, Soil Moisture Sensor, Flame Sensor Module, Hall Effect Sensor Module

Related Components: Microphone, LM393 Comparator IC, 10K Potentiometer, LED, Resistor

Brief about Sound Detection Sensor Module

This Sound Detection Sensor Module consists of a Microphone, resistors, capacitor, potentiometer, comparator LM393 IC, Power, and status LED in an integrated circuit.

LM393 IC

LM393 Comparator IC is used as a voltage comparator in this Sound Detection Sensor Module. Pin 2 of LM393 is connected to Preset (10KΩ Pot) while pin 3 is connected to Microphone. The comparator IC will compare the threshold voltage set using the preset (pin2) and the Microphone pin (pin3).

Microphone

The microphone in the Sound sensor module detects the sound. This sound is fed into the LM393 IC.

Preset (Trimmer pot)

Using the onboard preset, you can adjust the threshold (sensitivity) of the digital output.

Sound Detection Sensor Module Description

How to Use Sound Detection Sensor Module

Sound Detection Sensor Module consists of four pins i.e. VCC, GND, DO, AO. Digital out pin is connected to the output pin of LM393 comparator IC while the Analog pin is connected to Microphone. The internal Circuit diagram of the Sound Detection Sensor Module is given below.

Sound Detection Sensor Module Internal Circuit Diagram

Using Sound Detection Sensor Module with a microcontroller is very easy. Connect the Analog/Digital Output pin of the module to the Analog/Digital pin of Microcontroller. Connect VCC and GND pins to 5V and GND pins of Microcontroller. When the sound level exceeds the setpoint, an LED on the module is illuminated and the output is set low.