Skip to main content

433 MHz RF Receiver Module

Pin Configuration:

No:

Pin Name

Description

1

Vcc

Power supply (3V to 12V)

2

Data

Data received can be obtained from this pin

3

Data

It serves the same purpose (any one can be used)

4

Gnd

Connected to the ground of the circuit

5

Antenna

Solder wire/antenna to improve range (not mandatory)


433 MHz Module Specifications:

  • Wireless (RF) Simplex Transmitter and Receiver
  • Receiver Operating Voltage: 3V to 12V
  • Receiver Operating current: 5.5mA
  • Operating frequency: 433 MHz
  • Transmission Distance: 3 meters (without antenna) to 100 meters (maximum)
  • Modulating Technique: ASK (Amplitude shift keying)
  • Data Transmission speed: 10Kbps
  • Circuit type: Saw resonator
  • Low cost and small package

 

Note: The datasheet can be found at the bottom of the page

 

Other RF modules:

HC12, nRF24l01, nRF905

 

Other Wireless options:

Bluetooth, Lora, ESP8266, GSM, Xbee

 

Where to use 433 MHz RF Modules:

The 433MHz wireless module is one of the cheap and easy to use modules for all wireless projects. These modules can be used only in pairs and only simplex communication is possible. Meaning the transmitter can only transmit information and the receiver can only receive it, so you can only send data from point A to B and not from B to A.

The module could cover a minimum of 3 meters and with proper antenna a power supplies it can reach upto 100 meters theoretically. But practically we can hardly get about 30-35 meters in a normal test conditions.

So if you are looking for a simple wireless communication to transmit information within a short distance then these RF pair could be the right choice.

 

How to use 433MHz RF modules:

The module itself cannot work on its own as it required some kind of encoding before being transmitter and decoding after being received; so it has to be used with an encoder or decoder IC or with any microcontroller on both ends. The simplest way to use it is with the HT12E Encoder and HT12D Decoder IC.

The module uses ASK (Amplitude shift keying) and hence it’s easy to interface with microcontrollers as well. If you are trying to use this with Arduino, then the Radiohead library would make things easy for you. However you cannot expect noiseless data for a long distance form this module as this is very much susceptible to noise. The rage depends on the voltage supplied to Receiver and the noise present in the environment.

 

Applications:

  • Home automation
  • Transmit Serial data for short distance
  • Car security system
  • Wireless logging
  • Short distance communication

 

Dimension of the Module:

433 MHz RF Receiver Module Dimensions

Related Post



Join 20K+subscribers

We will never spam you.

* indicates required

Be a part of our ever growing community.