Skip to main content

TLV9004 Low Power, 4 Channel, 1MHz Op-Amp

The TLV9004 is a quad-channel low-voltage (1.8 V to 5.5 V) operational amplifier with rail-to-rail input and output swing capabilities. It is targeted to be used in space-constrained applications such as smoke detectors, wearable electronics, and small appliances where low-voltage operation and high capacitive-load drive are required.

 

Pin Description of TLV9004:

Pin Number

Pin Name

Description

1,7,8,14

Vout 1,2,3,4

Output pins of four op-amps

2,6,9,13

VIN- 1,2,3,4

Inverting input pin of four op-amps

3,5,10,12

VIN+ 1,2,3,4

Non-Inverting input pin of four op-amps

4

VD

Supply or positive rail

11

Vss

Ground or negative rail

               

Features of TLV9004:

  • Operating Voltage Range: 1.8V to 5.5V
  • Low input offset voltage: ±0.4 mV
  • Unity-gain bandwidth: 1 MHz
  • Low broadband noise: 27 nV/√Hz
  • Low input bias current: 5 pA
  • Low quiescent current: 60 µA
  • –40°C to +125°C extended the temperature range
  • Available in 14-pin PDIP, GDIP, PDSO packages

Note: Complete Technical Details can be found at the TLV9004 datasheet given at the end of this page.

 

Equivalent for TLV9004: MCP6004

Other Quad Op-Amps: LM324, TL084

 

Introduction to TLV9004:

The TLV9004 belongs to the TLV900x family of Op-Amps from Texas Instruments. The TLV900x family of low-power, rail-to-rail input and output operational amplifiers is specifically designed for portable applications. The class AB output stage is capable of driving less than or equal to 10‑kΩ loads connected to any point between V+ and V–. The input common-mode voltage range includes both rails and allows the TLV900x devices to be used in any single-supply application.

 

How to Use TLV9004

The circuit shown below is an example of a single-supply photodiode amplifier circuit using the TLV9002. Trans-impedance configuration of an amplifier is typically used to convert the low-level photodiode current to a voltage signal for processing in an MCU. The transfer function between the output voltage (VOUT), the input current, (IIN) and the reference voltage (VREF) is defined in the below equation

 

VOUT =  IN * RF + VREF

 

 TLV9004 as Amplifier Circuit Diagram

 

Applications of TLV9004

  • Smoke detectors
  • Motion detectors
  • Wearable devices
  • Large and small appliances
  • EPOS
  • Barcode scanners
  • Sensor signal conditioning
  • Power modules
  • Personal electronics
  • Active filters
  • HVAC: heating, ventilating, and air conditioning
  • Motor control: AC induction
  • Low-side current sensing

 

2-D Model of TLV9004

Dimensions for TLV9004 IC is given below. These dimensions are for the PDSO package. If you are using different package IC please refer to the TLV9004 datasheet.

TLV9004 Op-Amp Dimensions

Related Post



Join 20K+subscribers

We will never spam you.

* indicates required

Be a part of our ever growing community.